Repair procedures

Removal

1. Drain the power steering fluid.
2. Remove the joint assembly connecting bolt.





CAUTION:
Keep the neutral-range to prevent the damage of the clock spring inner cable when you handle the steering wheel.

3. Using the special tool (09568-4A000), disconnect the tie rod end from the knuckle arm.




4. Remove the front fork and the knuckle ball joint from the front lower arm.
5. Remove the connecting bolts of front and rear roll stopper.




6. Remove the mounting bolts(10EA) of cross member complete assembly.




7. Disconnect the pressure hose and the return tube.




8. Remove the steering gear box mounting bolts and remove the steering gear box assembly and the mounting rubber.





CAUTION:
When removing the gear box, pull it out carefully and slowly to avoid damaging the boots.

9. Remove the stabilizer bar.






Installation

NOTE:
Be sure to connect between a tube and a hose as shown in the illustration.




1. Installation is reverse of removal.
Tightening torque :





2. After installation, bleed the air in the power steering system .